Had a crash today and now I'm getting an error for the Transmitter signal being lost. It went into failsafe mode because the battery was low. On the way to land it hit a tree and fell to the ground.
Everything has the latest firmware. I've opened up the body of the P2 and everything looks fine. All the connectors look fine, no boards look cracked or broken. Antennas are attached to the receiver board. I've plugged the remote into the computer and confirmed the controls still work.
The LEDS are blinking yellow... The blink faster when I switch to Naza-M mode and slower in Phantom mode. The light on the RX binding button is solid red. If I press it then it will start to blink but it only blinds about 2 or 3 times then goes solid again. I cannot get it to see the transmitter. I've tried turning on the transmitter while pressing the bind button and still nothing. I've even tried going outside to the driveway to bind it thinking the wifi in the house may be causing problems. Still nothing
I've search multiple forums and haven't come upon anything that works..
Any idea?
Everything has the latest firmware. I've opened up the body of the P2 and everything looks fine. All the connectors look fine, no boards look cracked or broken. Antennas are attached to the receiver board. I've plugged the remote into the computer and confirmed the controls still work.
The LEDS are blinking yellow... The blink faster when I switch to Naza-M mode and slower in Phantom mode. The light on the RX binding button is solid red. If I press it then it will start to blink but it only blinds about 2 or 3 times then goes solid again. I cannot get it to see the transmitter. I've tried turning on the transmitter while pressing the bind button and still nothing. I've even tried going outside to the driveway to bind it thinking the wifi in the house may be causing problems. Still nothing
I've search multiple forums and haven't come upon anything that works..
Any idea?