Ya I will def post some pics. But now that I got in to this and doing some more test prints that are lighter I have thought of lots of ways to take that tube launcher design down even more on the weight if I change the design on the parts to make them not as thick and chunky in spots that its not needed. and could also use some holes added to the spring disk and the top that goes on the cat treat tube is way taller and thicker then it needs to be to at about 3/4 of an inch wide on the band that goes around the tube can easily be cut down 50% and would still leave plenty of room and strength to go around the top of the cat treat tube. The top lid also has a few places were it could shave more weight off on that by makeing it 1/2 as thick and the blocky parts that make the hing can be shorten and changed some. and a few holes or slots to take further plastic away still and It will still be just as sturdy. But the one other thing that chute launcher design needs is a good way to attach it to a bracket that could be for what ever craft its going on. Which it don't seem to have any way to attach it very good other then threw the bottom of the cat treat tube.
But I should be able to try a redesign on the launcher tube thing its self and get some weights and pics. For some visuals of this brain storming session.
But I should be able to try a redesign on the launcher tube thing its self and get some weights and pics. For some visuals of this brain storming session.