D
Deleted member 120647
Guest
So far my scenic flying tends to be from coastal cliff tops, I am wondering whether or not the takeoff point height would reset if I landed at the cliff bottom or what resets that height?
A couple of the local cliffs would threaten or breech the 400ft limit. I have seen a 'height' over -100m so far and that is not from the taller cliffs nor getting close to ground level. Yes I know I can raise the ceiling to 500m but I am curious as to what action resets the take off point height.
And NO this is NOT an attempt to climb a mountain etc. in steps.
It also prompts the question, where are the 'constraints' stored i.e. on the drone or the controller or the viewing device or some combination of the three?
A couple of the local cliffs would threaten or breech the 400ft limit. I have seen a 'height' over -100m so far and that is not from the taller cliffs nor getting close to ground level. Yes I know I can raise the ceiling to 500m but I am curious as to what action resets the take off point height.
And NO this is NOT an attempt to climb a mountain etc. in steps.
It also prompts the question, where are the 'constraints' stored i.e. on the drone or the controller or the viewing device or some combination of the three?