I thought this might be a good time to share with those interested on a project I finally found a little time to work on. What the pic's show is only a rough design. The 3D printer guy with will out the enhancements needed prior to flipping the go ahead switch.
The purpose of this piece is to improve the aerodynamics to reduce overall wind drag. In doing such, it will increase the flight time. Without any testing I have no idea how much improvement there will be. I can also add that what is seen in the pic's will change as would prefer it to not stick out as much, as well as the angle needs tweaking.
At this point I wanted to post something so if anyone wants to give some of their own thoughts.
The purpose of this piece is to improve the aerodynamics to reduce overall wind drag. In doing such, it will increase the flight time. Without any testing I have no idea how much improvement there will be. I can also add that what is seen in the pic's will change as would prefer it to not stick out as much, as well as the angle needs tweaking.
At this point I wanted to post something so if anyone wants to give some of their own thoughts.
