Hi guys,
I have a P2, Taranis x9d with the EZUHF-JR Model and the EZUHF Rx 8Channel.
Updated the firmware on both EZUHF Tx and Rx to the latest update...5.0
Did the binding procedure which seems to have taken properly because the Immersion RC Software finalized the Binding and indicated Binding was Complete...But the Red Indicator on the Rx is blinking more rapidly than what I've seen on Youtube videos...which indicate the blinking should be a nice slow calm heartbeat type blinking. Mine is about 2 blinks per second.
Assuming that it is Binded correctly, I also turned off the internal Transmitter of the Taranis and set the External for the EZUHF-JR which beeped 3 times indicating it was set as the Master. The RX being connected with 1 servo cable into any of it's 8 channels from the Naza M. I turn on the P2, the Taranis and I see what appears the blinking of the Rx and the Taranis with the EZUHF beeping 3 times...then the P2 Failsafe lights blink rapidly...I do not know why the P2 isn't seeing the EZUHF as the controller...
Can someone please give some guidance? I'd appreciate it very much.
Thanks
I have a P2, Taranis x9d with the EZUHF-JR Model and the EZUHF Rx 8Channel.
Updated the firmware on both EZUHF Tx and Rx to the latest update...5.0
Did the binding procedure which seems to have taken properly because the Immersion RC Software finalized the Binding and indicated Binding was Complete...But the Red Indicator on the Rx is blinking more rapidly than what I've seen on Youtube videos...which indicate the blinking should be a nice slow calm heartbeat type blinking. Mine is about 2 blinks per second.
Assuming that it is Binded correctly, I also turned off the internal Transmitter of the Taranis and set the External for the EZUHF-JR which beeped 3 times indicating it was set as the Master. The RX being connected with 1 servo cable into any of it's 8 channels from the Naza M. I turn on the P2, the Taranis and I see what appears the blinking of the Rx and the Taranis with the EZUHF beeping 3 times...then the P2 Failsafe lights blink rapidly...I do not know why the P2 isn't seeing the EZUHF as the controller...
Can someone please give some guidance? I'd appreciate it very much.
Thanks