robinb said:I will look at that if I have problems in future.
I did tweak v1 as it was not doing correct rotation but after a quick tweak it worked fine.
Nice. So you adjusted the gains or the pitch ?
Also you are using a gopro ?
robinb said:I will look at that if I have problems in future.
I did tweak v1 as it was not doing correct rotation but after a quick tweak it worked fine.
robinb said:you do not get FPV when recording.
dragonash said:after the settings are complete, I actually adjust V1 and V2 for horizon level and amount of tilt when using the pitch lever on the controller.
The adjusters act different when you arent in that PAM mode
Carl4 said:dragonash said:after the settings are complete, I actually adjust V1 and V2 for horizon level and amount of tilt when using the pitch lever on the controller.
The adjusters act different when you arent in that PAM mode
Did that clean up the shake ?
Carl4 said:robinb said:you do not get FPV when recording.
1080P No pro tunes will give you live preview and record. (Slightly off topic)
robinb said:Carl4 said:robinb said:you do not get FPV when recording.
1080P No pro tunes will give you live preview and record. (Slightly off topic)
? no FPV when recording
robinb said:yes, that is what i am saying.
Carl4 said:I had the gimbal replaced. New one works much better. I tested with both stock FC40 props and vision props. Both work really nice with it.
[youtube]https://www.youtube.com/watch?v=r7OsLdc2cyk[/youtube]
https://www.youtube.com/watch?v=r7OsLdc2cyk
Carl4 said:Still a little, but much better then before. I was flying in about 9mph wind with GPS on. I wanted to give it another test with the softer rubber dampeners that come from DJI with it in ATT mode.
Even if I cant fix that last bit of jello I would consider it worth the 89 dollars I paid for it on newegg.
http://www.newegg.com/Product/Product.a ... -_-Product
ChrisV said:I already posted this in another thread before coming across this one. I installed the G-2D on my FC40, powered everything up and connected to software. I enabled the Gimbal. I tried to calibrate the X1 stick but I'm not sure if I'm doing it right. I adjust the V1 and the camera stopped shaking as if it were having a seizure (jellowing?) It now sits there pointing up. When I adjust the lever on the transmitter the gimbal starts wigging out and points down then snaps back up again repeatedly. It also starts rolling left and right. I am using the FC40 camera with some zipties. I also added 20grams of weight. Any suggestions?
Thanks in advance.