hey guys I just got my 1st phantom 3 advanced was looking forword to get going after an hr of downloading firmware and charging batteries ! wow . well I think I got everything downloaded but I went outside to fly and my controller red led light blinks and a beep everytime I turn controller on? it told me I needed new firmware so I downloaded it then said it was ok to fly so I went to throttle up nothing ? so I did the auto take off I hit the button and went half foot off the ground and flipped over to the left anyway I tried 3 times and broke 3 blades ! im at a loss I calibrated it I think I did everything it told me to do ? the controller only works the camera movement but no throttle or nothing ? only thing that works is the auto fly button ? nothing els ? I had a $100 drone before this and worked fine .im just at a loss and a little upset. can somebody please tell me what im doing wrong I just want to see it hover fly take some vids thanks everyone.
<<Moved to correct forum>>
<<Moved to correct forum>>
Last edited by a moderator: