Info on this is quite sparse and over at least 3 different forums.
Replacing the crap lever on the back with a rotary linear pot.
What pot did you use. I see 5k ohm mentioned a lot but also a 1k ohm with resistors.
How many turns is your pot? 1 turn? less than 1?, 3?
Do you use the full range?
Any problems? I saw in one thread where someones controller stopped working after using a 5k ohm pot. I know the stock pot is 5k ohm but it only uses a small section of it.
Where have you positioned the knob?
Long term successful users most welcome.
Many thanks for any info.
Replacing the crap lever on the back with a rotary linear pot.
What pot did you use. I see 5k ohm mentioned a lot but also a 1k ohm with resistors.
How many turns is your pot? 1 turn? less than 1?, 3?
Do you use the full range?
Any problems? I saw in one thread where someones controller stopped working after using a 5k ohm pot. I know the stock pot is 5k ohm but it only uses a small section of it.
Where have you positioned the knob?
Long term successful users most welcome.
Many thanks for any info.