Well, I was finally able meet up with another
P4P owner today since its been nothing but rain, high winds, darkness, and traveling since I posted this. However we were out today for about 45 minutes flying and my conclusion is unfortunately my
P4P with the Titan Conqueror panel didn't get anywhere near his distance. He even restricted his to 2.4Ghz in Auto mode so we would operate on the same frequency.
After approximately 2412 feet at 289 foot altitude the transmission signal started to cut out and at around 2500 ft it was completely gone and it returned home in recovery mode. Sent it up 3 different times in 3 different directions and every time it was similar results. About 2400-2500 feet and the signal would cut out. I kept the controller and panel pointed almost directly at the drone the entire time as I was flying primarily in a straight line it was pretty simple to do.
Just to make sure it wasn't a problem with the drone we switched remotes. I flew his drone using the titan panel remote, again max distance around 2500 from where we were standing. I think the max we got with the titan panel all day was ~2700 feet away.
He flew my drone, using his remote and off it went faaar faar out there. When he used the 5.8ghz frequency on either drone, it was almost embarrassing to be standing there with a $300 "range extender" while stock out performed it.
I dont think its an issue with the controller mod as it was super simple and straight forward and all the connections are tight and everything is neatly tucked away inside. I'm going to contact Titan today and see if they have any tips or recommendations.