PLEASE HELP
a few days ago after successful flights I took Phantom 2 Vision to a new location. Right away when everything booted up my screen said to recalibrate compass, I did. I lifted off and it was very difficult to control. Yes there was a slight breeze but nothing the Phantom should not have been able to handle as in the past. Well, it was all over and basically I lost control of it and it hit a chain link fence. Broke my Dronexpert gimbal and a couple of props. Im trying to figure out what went wrong. Again, it became uncontrollable and it appeared it was fighting with itself to maintain control. Since then I have upgraded all firmware. Upgraded the transmitter firmware. I have calibrated the transmitter, tighten all screws and props, calibrated the compass at lease 5 times in an open field. AND it still too hard to control. I have been at the park 3 different times today and no matter what I have done it is still behaving the same. The only additions I have made to this phantom is installed the dronexpert gimbal and 7 channel on back of transmitter. WHAT AM I MISSING. Any help would be very appreciated. Thank you. Ralph.
a few days ago after successful flights I took Phantom 2 Vision to a new location. Right away when everything booted up my screen said to recalibrate compass, I did. I lifted off and it was very difficult to control. Yes there was a slight breeze but nothing the Phantom should not have been able to handle as in the past. Well, it was all over and basically I lost control of it and it hit a chain link fence. Broke my Dronexpert gimbal and a couple of props. Im trying to figure out what went wrong. Again, it became uncontrollable and it appeared it was fighting with itself to maintain control. Since then I have upgraded all firmware. Upgraded the transmitter firmware. I have calibrated the transmitter, tighten all screws and props, calibrated the compass at lease 5 times in an open field. AND it still too hard to control. I have been at the park 3 different times today and no matter what I have done it is still behaving the same. The only additions I have made to this phantom is installed the dronexpert gimbal and 7 channel on back of transmitter. WHAT AM I MISSING. Any help would be very appreciated. Thank you. Ralph.