And back with more issues. Got the gimbel installed, ran the update with the Naza assistant and then tried to set the tilt control on X1. The red arrow on the X1 calibration screen just jumps around when I hit calibrate. At the same time the gimbel is twitching back and forth in tilt. I enbabled teh gimbel switch in the Assistant. Any other settings to check? Gimbel update is 1.4, P330 is showing 1.1.2.1. Should I be using RC assistant for P1 or P2 since I upgraded my board? I see some people shorting pins out on the gimbel to reset the gimbel to fix this issue. I see some people upgrading the gimbel software again to fix twitching. What a cluster.
UPDATE, reading more H3-3D topics here it appears it's a 50-50 chance you actually get a gimbel that works. Outfreaking standing DJI. All the baloney to get this thing hooked up and then it just twitches like a tuna on a boat deck. $400 for all this? I don't think so. I do hope they take returns. I see DJI takes 2-3 days to even answer their dang customer service emails. Any other drones to use, this POS may be going on ebay real fast.
UPDATE, reading more H3-3D topics here it appears it's a 50-50 chance you actually get a gimbel that works. Outfreaking standing DJI. All the baloney to get this thing hooked up and then it just twitches like a tuna on a boat deck. $400 for all this? I don't think so. I do hope they take returns. I see DJI takes 2-3 days to even answer their dang customer service emails. Any other drones to use, this POS may be going on ebay real fast.