I see what you're saying about the longer lever but it seems like there ought to be an adjustment in the amount of rotation of the control pot to give the desired angle of pitch travel on the gimbal. I've tried programming the X1, which is the 7th channel, in both the RC Assistant as well as the Phantom Assistant to no avail.
I did some resistance measurements on the pot and was seeing about 1500 ohms in a quarter turn of the pot and then the resistance went back to zero during the rest of the half turn travel. Would seem like maybe a 750 ohm pot would be about right.
May have to break down and do the conversion that puts the 7th channel pot on top of the radio control. Anyone know where to find that on this forum?
I did some resistance measurements on the pot and was seeing about 1500 ohms in a quarter turn of the pot and then the resistance went back to zero during the rest of the half turn travel. Would seem like maybe a 750 ohm pot would be about right.
May have to break down and do the conversion that puts the 7th channel pot on top of the radio control. Anyone know where to find that on this forum?