Hello Everyone,
I'm definitely a noob to this hobby, and just bought a used FC40. It works great, except that I can't get it to not climb with the stick neutral, it just goes up to beyond where I lose wifi to the camera before I have to reduce throttle below neutral. I've replaced the stock motors with the T-Motors and am running the original style props. I've connected to the Naza software and checked all settings, updated to latest available firmware and even reduced the vertical gain to 70%. I have good GPS signal per the LED, and it will come home and auto land on low battery. A couple of odd things I've noticed are 1. when I first start the props, they seem to operate on like a low idle speed, then without any input from the control they speed up, and 2. the other day I had a slight crash and after I restarted, it tried to maintain hover at about 8ft of altitude, but wouldn't maintain any lower.
Any and all ideas and thoughts are welcome.
Thank you!
I'm definitely a noob to this hobby, and just bought a used FC40. It works great, except that I can't get it to not climb with the stick neutral, it just goes up to beyond where I lose wifi to the camera before I have to reduce throttle below neutral. I've replaced the stock motors with the T-Motors and am running the original style props. I've connected to the Naza software and checked all settings, updated to latest available firmware and even reduced the vertical gain to 70%. I have good GPS signal per the LED, and it will come home and auto land on low battery. A couple of odd things I've noticed are 1. when I first start the props, they seem to operate on like a low idle speed, then without any input from the control they speed up, and 2. the other day I had a slight crash and after I restarted, it tried to maintain hover at about 8ft of altitude, but wouldn't maintain any lower.
Any and all ideas and thoughts are welcome.
Thank you!