Flying today and everything was working great. Forgot to put my SD back in, landed, turned off the P4P+, put it back in, then bam no camera signal. It stays on the camera, and I can't switch to video now either, and it says that the gimbal is disconnected?!?
Usually you can disconnect the cable from your iPad turn the control off, then restart the app. Then connect the wire and start up the control it worked for me.
Usually you can disconnect the cable from your iPad turn the control off, then restart the app. Then connect the wire and start up the control it worked for me.
The last required update made my p4p+ nuts after it finally took hold. Had to revert to previous version and good as new.
I'm a new pilot and that was no fun to figure out.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.