Hi all,
I made another video disassembling the drone. It is my final cry for help before I scrap this to others for parts...
It seems the gimbal cable would not even fit even if I could get a new cable (which I can't until July). My guess that while manufacturing this, an 8 ribbon cable is put through the hole and then after the ends are soldered on.
Can anyone with any experience in building electronics confirm this? If I buy an 8 ribbon cable from this site, (I plead ignorance on the topic, I chose this based on an educated guess)
http://www.digikey.com/product-detail/en/AWG28-08/G-1/300-R/AE08A-10-ND/2391673
can I just solder the cable ends into the plastic clips?
Please advise
Thanks
I made another video disassembling the drone. It is my final cry for help before I scrap this to others for parts...
It seems the gimbal cable would not even fit even if I could get a new cable (which I can't until July). My guess that while manufacturing this, an 8 ribbon cable is put through the hole and then after the ends are soldered on.
Can anyone with any experience in building electronics confirm this? If I buy an 8 ribbon cable from this site, (I plead ignorance on the topic, I chose this based on an educated guess)
http://www.digikey.com/product-detail/en/AWG28-08/G-1/300-R/AE08A-10-ND/2391673
can I just solder the cable ends into the plastic clips?
Please advise
Thanks