Hello! Got my phantom in yesterday and went for a small test run after work. Got back home and upgraded the Naza to 4.02. After this upgrade I have not been able to get my Tx to work. I have tried calibrating it, upgrading the firmware again, rebinding it (press switch in phantom until it blinks red then turn on the Tx). When the phantom turns on I get continuous yellow flashes. I have imported the parameters from the DJI website. Even went through this video to make sure I was doing some of these steps right:
http://www.youtube.com/watch?v=Rx0YHQeWaj8
On the software assistant if I choose the D-BUS receiver I can see the calibrations on the screen move. But to my understanding this is a PPM receiver (Stock Phantom).
EDIT:
After some more reading I found this: http://www.phantompilots.com/viewtopic.php?f=5&t=3454
last post states the following:
I am going to try this out and see what happens.
http://www.youtube.com/watch?v=Rx0YHQeWaj8
On the software assistant if I choose the D-BUS receiver I can see the calibrations on the screen move. But to my understanding this is a PPM receiver (Stock Phantom).
EDIT:
After some more reading I found this: http://www.phantompilots.com/viewtopic.php?f=5&t=3454
last post states the following:
It is a bit frustrating. Two or three firmware upgrades ago the release notes mentioned that the D-Bus port now support S-Bus and PPM . It does not make the point that if your Phantom is the latest with the new receiver (with two antennas) the receiver type is now D-Bus, NOT PPM. We wasted hours over the weekend after a firmware upgrade to 4.02 with flashing yellow lights when the cure was a simple mouse click to the new receiver type
I am going to try this out and see what happens.