I just ordered Immersions 25mw FPV set. And yes, I know that I will get pretty short range with 25mw... But it was the only way to go if I wanna stay legit. My Phantom is v.1.1.1
Any tips for the installation process?
-Should I take the power from ESC or...?
-Links
-Do's and dont's
I bet its not wise to install the transmitter within the Phantom casing as it may get hot in there? So any DIY/MacGyver suggestions how to attach the transmitter below the Phantom. I'm not gonna order any 3D printed parts for this
Transmitter
http://www.hobbyking.com/hobbyking/stor ... duct=52417
Receiver
http://www.hobbyking.com/hobbyking/stor ... utput.html
Any tips for the installation process?
-Should I take the power from ESC or...?
-Links
-Do's and dont's
I bet its not wise to install the transmitter within the Phantom casing as it may get hot in there? So any DIY/MacGyver suggestions how to attach the transmitter below the Phantom. I'm not gonna order any 3D printed parts for this
Transmitter
http://www.hobbyking.com/hobbyking/stor ... duct=52417
Receiver
http://www.hobbyking.com/hobbyking/stor ... utput.html