- Joined
- Oct 26, 2013
- Messages
- 21
- Reaction score
- 0
In naza assistant if I move the sticks then A/E/T/R displays move exactly as expected (calibrated to -1000 - 1000).
If I calibrate the gimbal on X1 - then it moves from end to end just fine (again -1000 to 1000).
But if I flip the left or right switch then I see nothing. No movement. Nothing moves on the front display screen showing channel output or on the RC Control Mode Switch or Advanced IOC X2 page.
This worked fine when I packed the quad down some weeks back - but today it doesn't. And I'm confused. Any suggestions?
Just in case if relevant:
Software
Assistant 2.20
Firmware
MC 4.02
GPS 6.0.1.3
RX 1.0.0.18
P330CB-H3-2D 1.1.2.1
CMU 1.0
IMU 1.4
If I calibrate the gimbal on X1 - then it moves from end to end just fine (again -1000 to 1000).
But if I flip the left or right switch then I see nothing. No movement. Nothing moves on the front display screen showing channel output or on the RC Control Mode Switch or Advanced IOC X2 page.
This worked fine when I packed the quad down some weeks back - but today it doesn't. And I'm confused. Any suggestions?
Just in case if relevant:
Software
Assistant 2.20
Firmware
MC 4.02
GPS 6.0.1.3
RX 1.0.0.18
P330CB-H3-2D 1.1.2.1
CMU 1.0
IMU 1.4