Might be of interest to someone.
When I found it kind of tricky to remove the SD card from my Phantom 3,
I added this little tab I made from a Shaped paper clip.
The tab was very carefully glued on the edge of the card with Cyanoacrylate
hobby glue and it has really made the card removal/insertion effortless.
If you do do this, be careful not to get the glue on the "sides" of the card as the
slot the card goes in is a pretty close tolerance'
Also, make sure the card will still fit your Computer SD Card Reader after you do this.
When I found it kind of tricky to remove the SD card from my Phantom 3,
I added this little tab I made from a Shaped paper clip.
The tab was very carefully glued on the edge of the card with Cyanoacrylate
hobby glue and it has really made the card removal/insertion effortless.
If you do do this, be careful not to get the glue on the "sides" of the card as the
slot the card goes in is a pretty close tolerance'
Also, make sure the card will still fit your Computer SD Card Reader after you do this.
Last edited: