- Joined
- Jul 24, 2014
- Messages
- 23
- Reaction score
- 6
Hi there,
I am having trouble getting the Naza M v2 to properly recognize my Futaba T8j and receiver. I have gone through forums and videos and think I have my T8J setup properly now. I have a solid green light on the Futaba receiver. I have the Sbus channel on the Receiver going to the X2 input on the naza. I have the PMU on the X3 input of the NAZA. The only other wires I have in the Naza are the motor connections. The receiver has a solid green light on it and it seems to be bound to the transmitter. (My first experience with Futaba)
The problem is that when I open the Assitant software (Mac Version) I get a TX configuration error saying I need to reset my Transmitter and recalibrate. Unfortunately when I go to the RC setup the T8J is not recognized. (it has never shown up properly at this stage)
I tried reset to defaults and get a warning when doing so however after clicking reset nothing changes or goes back to Factory settings. Even when I disconnect the receiver completely I get this error.
I was wondering if anyone knew of a hard reset for the NAZA M so I can get back to square one?
Any ideas from those a whole lot smarter than I am?
Thank-you.
I am having trouble getting the Naza M v2 to properly recognize my Futaba T8j and receiver. I have gone through forums and videos and think I have my T8J setup properly now. I have a solid green light on the Futaba receiver. I have the Sbus channel on the Receiver going to the X2 input on the naza. I have the PMU on the X3 input of the NAZA. The only other wires I have in the Naza are the motor connections. The receiver has a solid green light on it and it seems to be bound to the transmitter. (My first experience with Futaba)
The problem is that when I open the Assitant software (Mac Version) I get a TX configuration error saying I need to reset my Transmitter and recalibrate. Unfortunately when I go to the RC setup the T8J is not recognized. (it has never shown up properly at this stage)
I tried reset to defaults and get a warning when doing so however after clicking reset nothing changes or goes back to Factory settings. Even when I disconnect the receiver completely I get this error.
I was wondering if anyone knew of a hard reset for the NAZA M so I can get back to square one?
Any ideas from those a whole lot smarter than I am?
Thank-you.