So I got my RE700 ... went into the app and scanned the QR code from my original box for my Phantom. App populated fields for the SSID and the MAC for the camera just fine, reported back SUCCESS. When I check the "blue arrow" to accept, all looks well, but it appears the RE700 reboots programmatically at that point, and then it never advertises its SSID again. Before the bind, it advertises its "Phantom_XXX" SSID just fine, lets anyone connect, gives out IP addresses, etc - works fine. But once I bind, even though the app reports success, it never advertises again, and, of course, I'm grounded until all that resolves so the app can see what's going on. I can reset the RE700 with a paper-clip and repeat all this over and over. Weird thing now is that my old RE500 won't bind back now to the way it was - which was working great. Same exact scenario with the RE500 now trying to fail-back. Any ideas ???