Venom93corba said:
Does anybody down how to downgrade? I just received my P2V+ and want to put 1.08 on it just not sure how.
Windows instructions for downgrade from PT2 2.00 or PT2 3.0 to PT2 1.08. This will work with the Phantom Vision and also with the Phantom Vision+. I'm pretty sure it will also work with non-Vision Phantom 2 models but can't personally verify that fact.
1. Download and install PT2 version 1.08 from
http://droneslinger.com/software.html (or any other location where the program is available).
2. Start PT2 program
3. Plug mini-USB cable into the port on the front of the Phantom
4. Plug USB end of the mini-USB cable into computer
5. Turn on the remote control of the Phantom. (It is not necessary to turn on the range extender.)
5a. Power on the Phantom
6. Phantom will connect to PT2 program
7. A pop-out screen will say that version 3.0 is now available. Click the “Close” button on that screen.
8. The “upgrade” tab of the PT2 software should be the one that you see in front of you.
9. On the right side of that screen near the top of that screen you will see “Latest version: 1.08”. Click on it!
10. A pop-out screen will show that says: “Firmware Upgrade” at the top. Below that you’ll find “Device Name: Main Controller Current version: 2.0 Upgrade to: 1.08”
Below the black screen is: “Download successfully! Refresh.” (There is no need to click on Refresh). Below that are two boxes, “Upgrade” and “Exit”.
11. Click on “Upgrade”.
12. Click “Yes” on the warning screen that comes up.
13. When upgrade complete, turn Phantom battery off, then back on again.
14. Make all adjustments, calibrations, etc.
15. Turn off Phantom
16. Turn off remote control
17. Disconnect mini-USB cable from Phantom
18. Close PT2 program