Hi all,
Relative newbie here, wishing the wind would calm down so I can fly more. I read the fantastic PDF guide cover to cover before I even unboxed, and have always had my P2V+ in NAZA mode (as it enables IOC functions and with both switches UP it's in GPS mode anyways). Most of the time I fly in GPS, but always make sure I put some time into ATTI - it's really not that difficult, but I'm a total newbie to RC so being careful.
I recently asked the question "other than pure fun, is there any reason to have MANUAL mode available and learn to fly it". In short, the answer was that if the P2V+ has a screwed up GPS fix and thinks it's outside the fence, it will try to return to the fence. ATTI mode won't give you control back. Since I can imagine several circumstances this could happen (loose GPS connector, Dynamic Home Point sending bad GPS position from phone, to name but 2) it makes sense to me to have MANUAL enabled as S1 bottom position and learn to fly it.
My little HUBSAN that I practise on has TRIM - the P2V+ controller doesn't. Is that a big problem ?
Relative newbie here, wishing the wind would calm down so I can fly more. I read the fantastic PDF guide cover to cover before I even unboxed, and have always had my P2V+ in NAZA mode (as it enables IOC functions and with both switches UP it's in GPS mode anyways). Most of the time I fly in GPS, but always make sure I put some time into ATTI - it's really not that difficult, but I'm a total newbie to RC so being careful.
I recently asked the question "other than pure fun, is there any reason to have MANUAL mode available and learn to fly it". In short, the answer was that if the P2V+ has a screwed up GPS fix and thinks it's outside the fence, it will try to return to the fence. ATTI mode won't give you control back. Since I can imagine several circumstances this could happen (loose GPS connector, Dynamic Home Point sending bad GPS position from phone, to name but 2) it makes sense to me to have MANUAL enabled as S1 bottom position and learn to fly it.
My little HUBSAN that I practise on has TRIM - the P2V+ controller doesn't. Is that a big problem ?