I have received my Vision 2+ V3.0 now since two days, have not dared to open it and unpack it. After reading so much about what could happen for untrained pilots and the most likely damage that can occur is scaring me to even take it out. Anyhow, eventually I will do so after reading more about it and watching more videos, however, one thing is for sure that this forum has helped a lot in answering so many questions. When it came to my other question in another area on this forum regarding antenna and increased power, some recommended if I can replace the vision with gopro model, unfortunately it was too late as it was already on the way. Meanwhile, through this forum I was able to reach a point of extending in a very reasonable price the WiFi range setup using the TPLink way.
The biggest fear so far is tearing the gimbal and camera tape wiring in the event of an unfortunate accident on the first flight. Hence, I went and searched for replacements and I found these, and without paying to much attention to details I ordered a couple just in case, unfortunately I discovered afterwards they are not originals and a bit pricey (currently on their way). The following is the site on eBay. The question is: Are they dependable as the original cables?
http://www.ebay.com/itm/191437286490?_t ... EBIDX%3AIT
Finally any last minute advices before I take my Quad out for its maiden flight.
Regards,
Sarie
The biggest fear so far is tearing the gimbal and camera tape wiring in the event of an unfortunate accident on the first flight. Hence, I went and searched for replacements and I found these, and without paying to much attention to details I ordered a couple just in case, unfortunately I discovered afterwards they are not originals and a bit pricey (currently on their way). The following is the site on eBay. The question is: Are they dependable as the original cables?
http://www.ebay.com/itm/191437286490?_t ... EBIDX%3AIT
Finally any last minute advices before I take my Quad out for its maiden flight.
Regards,
Sarie