Good first flight. Brand new out of box. Upgraded all firwmare; bird, batter, and RC. Calibrated compass and IMU. Stayed in "beginner" mode and took some video and stills.
Two part flight. Took off, up and down, then landed (hand caught). Took off again, flew the same pattern, up and around a little (beginner mode doesn't allow for much). Towards the tail end of the flight the camera instantly turned to a position, then the gimbal went limp, then it camera instantly turned in a number of very direct positions. As I watched this on my iPad I assumed it was crashing to the ground as the image being presented was "side ways" but as I looked up the bird was fine just the gimbal and camera were acting up. And by "acting up" I mean violently moving to different positions and going limp.
Any thoughts?
Two part flight. Took off, up and down, then landed (hand caught). Took off again, flew the same pattern, up and around a little (beginner mode doesn't allow for much). Towards the tail end of the flight the camera instantly turned to a position, then the gimbal went limp, then it camera instantly turned in a number of very direct positions. As I watched this on my iPad I assumed it was crashing to the ground as the image being presented was "side ways" but as I looked up the bird was fine just the gimbal and camera were acting up. And by "acting up" I mean violently moving to different positions and going limp.
Any thoughts?
Last edited: