Hello,
I'm a proud new owner of a used P3p. I bought it without a Tx or charger. I found a 100w charger at Best Buy, and after reading your comments and input, I found a used " A " model Tx, on eBay.
Bird : model: w323
Tx: model: GL300A
I'm using an iPhone 4s, until I can afford an iPad or other tablet to use ( iPhone just too small )
iOS version 9.3.2. Not newest, but 1 step behind.
Ok
Bird firmware ( UNKNOWN )
Tx firmware ( UNKNOWN )
Go app ( 2.8.2 ) already had it on iTunes, as I read a Lot of bad reviews on newest version.
My delema:
A) not sure which firmwares work together with which app version
&
B) biggest issue
( phantom and Tx are not bound )
I cannot get the iPhone app to hook to Tx, ( only get the HOW TO CONNECT message )
Therefore cannot bind to bird!
( or is there an alternate route? )
I was going to try to download the newest Tx firmware ( from DJI.com p3 downloads ) to a removeable USB drive, then plug into Tx, to see if it will update!
Is this the only choice I have?
I did search, but all say turn on bird but mine is not bound, so I'm at a loss? Or I'm overlooking something?
Any help or advice is GREATLY APPRECIATED! I usually try to figure these things out for myself, but this one stumps me! Probably a typical newbie mistake I'm sure!
Thanks,
J Dot
I'm a proud new owner of a used P3p. I bought it without a Tx or charger. I found a 100w charger at Best Buy, and after reading your comments and input, I found a used " A " model Tx, on eBay.
Bird : model: w323
Tx: model: GL300A
I'm using an iPhone 4s, until I can afford an iPad or other tablet to use ( iPhone just too small )
iOS version 9.3.2. Not newest, but 1 step behind.
Ok
Bird firmware ( UNKNOWN )
Tx firmware ( UNKNOWN )
Go app ( 2.8.2 ) already had it on iTunes, as I read a Lot of bad reviews on newest version.
My delema:
A) not sure which firmwares work together with which app version
&
B) biggest issue
( phantom and Tx are not bound )
I cannot get the iPhone app to hook to Tx, ( only get the HOW TO CONNECT message )
Therefore cannot bind to bird!
( or is there an alternate route? )
I was going to try to download the newest Tx firmware ( from DJI.com p3 downloads ) to a removeable USB drive, then plug into Tx, to see if it will update!
Is this the only choice I have?
I did search, but all say turn on bird but mine is not bound, so I'm at a loss? Or I'm overlooking something?
Any help or advice is GREATLY APPRECIATED! I usually try to figure these things out for myself, but this one stumps me! Probably a typical newbie mistake I'm sure!
Thanks,
J Dot