- Joined
- Aug 14, 2015
- Messages
- 81
- Reaction score
- 6
- Age
- 55
can you run ur iPad and headplay goggles at the same time on the board? And is there a setting in the dji go app for the hdmi to the goggles
I installed mine today also and got the same message. I was already on 1.3.2. Touch on the upgrade notice and it will give you the opportunity to upgrade the controller again. Make sure you have more that 50% battery per the instructions and Hit Start upgrade. Mine upgraded again 1.3.2 and after the upgrade, rebooted everything and all showed to be normal.Here is the screenshoot.
As the app don't report the version of the drone and controller independently, I just noticed that the version had become older after the HDMI addition. Before drone and controller where to latest, 1.3.2. So I updated only the controller back to 1.3.2.Thnx for your help! did you say you went back to the same firmware that is on the drone on the controller
The drone has probably no good GPS signal and its internal clock start from some default value like 1st January 2008. I had already observed that during upgrade.There is on more thing, when I try to reinstall the firmware on drone to make sure that isn't the problem it starts blinking green and red like it is suppose to then it goes a solid red and stays red till the battery about runs out. I check the card on the computer and it says success, but the date is way off. Does that help?
Actually I have not try a flight with the HDMI installed, my glasses should arrive tomorrow. Only played little with it at home to check assembly. Will tell you results and see if I get same issue.So this is all of it in a nutshell ! When I'm in video mode I hit record and the screen goes black, records for 1 sec , screen goes black and switches to camera mode and I loose signal on controller for a short period of time. I'm able to fly on camera mode , the signal isn't as strong, I cant see no where near as far . I have headplay goggles that wont work anymore, blue screen, all my settings are like Dronason sent me on my ipad. when I redo the firmware it stays solid red but says its a success but date is way off and I'm getting a compass error reading every other time I use it which fixes when you restart the controller or drone. IS THERE ANYWAY TO RESET EVERYTHING TO WHEN IT WAS NEW AND START OVER ? I have switched out antennas, switched out light bridges , tried different controllers, different ipads, iphones ect..
In the .txt file on the SD, did it say fail or success?I cant get my drone to do the firmware update, blinks green and red for a minute and goes solid red