OK...so I converted my Futaba T8J transmitter to a self-centering throttle to match the manner in which the v.1.1.1 Phantom transmitter is supplied. I GREATLY prefer this arrangement and made the conversion in part because I'm going to install a Futaba Rx into the Phantom as a next step. The problems that have now arisen are two-fold.
Problem one I have created is that the the transmitter alarms because the throttle is not at zero. This is a standard warning with the Tx. Pretty sure I read how I can over-ride this by pressing and holding the + and - or some such.
The greater problem by far is with the NAZA Lite that is installed on my OFM Jumper 600. The NAZA-M lite Assistant software is giving me a <<CFG_ERR>> or configuration error. Clearly, it ALSO is showing concerns that the "centered throttle" is not being perceived as the zero throttle set point. How do I overcome this? Do I need to calibrate the transmitter? I know how it is done with the Phantom transmitter, but what is the procedure for properly calibrating the Futaba? Or is the answer more a more complicated matter of settings in the Futaba T8J????
I need explicit instructions/guidance. I've never done this before, but I KNOW others have. What in heavens name do I need to do???? Once accomplished I can put the Futaba receiver in the Phantom and program the Tx for both craft.
Please HELP me if you can!!!
Thanks in advance.
PF
Problem one I have created is that the the transmitter alarms because the throttle is not at zero. This is a standard warning with the Tx. Pretty sure I read how I can over-ride this by pressing and holding the + and - or some such.
The greater problem by far is with the NAZA Lite that is installed on my OFM Jumper 600. The NAZA-M lite Assistant software is giving me a <<CFG_ERR>> or configuration error. Clearly, it ALSO is showing concerns that the "centered throttle" is not being perceived as the zero throttle set point. How do I overcome this? Do I need to calibrate the transmitter? I know how it is done with the Phantom transmitter, but what is the procedure for properly calibrating the Futaba? Or is the answer more a more complicated matter of settings in the Futaba T8J????
I need explicit instructions/guidance. I've never done this before, but I KNOW others have. What in heavens name do I need to do???? Once accomplished I can put the Futaba receiver in the Phantom and program the Tx for both craft.
Please HELP me if you can!!!
Thanks in advance.
PF