Hello all,
I had a mishap today with my FC40 where a tree limb reached out and touched me in a bad way. Drone dropped from about 20 feet. After which the LED started to flash yellow.
I brought it home and did a little looking inside to see if something had pulled apart. Nothing was observed.
Then I connected the USB to computer and opened Assistant. Got a Error (29) and have not found a solution.
I started the calibration of the controller as suggested using the RC Assistant and all looks good.
When I use Nazam Assistant I can check the motors but when I go to Basic/RC I get no response.
At the bottom I have a Green LED with Flashing Blue LED. MODE: Failsafe MC OUTPUT: OFF
Under Control Mode Switch it seems to be locked on Failsafe (in Blue) I can't seem to find a way to change that. When I choose START Calibration nothing changes when I move the sticks.
I have done a "Restore default settings" and "Reset BTU Info" none of which makes any difference.
I have done an "Advance Calibration" on the "Tools" tab and get a warning about "Temperature of MC is too high, to achieve best effect of calibration, please power off of MC, cooling for 5 minutes and then re-do the Advanced Calibration.
I did all of that and nothing changes.
After all of this I am at a loss of what the problem is and what the solution might be.
Anyone have a clue or a hint??
Thanks in advance for any assist.
Les
I had a mishap today with my FC40 where a tree limb reached out and touched me in a bad way. Drone dropped from about 20 feet. After which the LED started to flash yellow.
I brought it home and did a little looking inside to see if something had pulled apart. Nothing was observed.
Then I connected the USB to computer and opened Assistant. Got a Error (29) and have not found a solution.
I started the calibration of the controller as suggested using the RC Assistant and all looks good.
When I use Nazam Assistant I can check the motors but when I go to Basic/RC I get no response.
At the bottom I have a Green LED with Flashing Blue LED. MODE: Failsafe MC OUTPUT: OFF
Under Control Mode Switch it seems to be locked on Failsafe (in Blue) I can't seem to find a way to change that. When I choose START Calibration nothing changes when I move the sticks.
I have done a "Restore default settings" and "Reset BTU Info" none of which makes any difference.
I have done an "Advance Calibration" on the "Tools" tab and get a warning about "Temperature of MC is too high, to achieve best effect of calibration, please power off of MC, cooling for 5 minutes and then re-do the Advanced Calibration.
I did all of that and nothing changes.
After all of this I am at a loss of what the problem is and what the solution might be.
Anyone have a clue or a hint??
Thanks in advance for any assist.
Les