I have just replaced the bottom shell on my 3 pro because of hairline cracks around a motor base.
Never been crashed or damaged in any way other than the hairline cracks from motor torque.
firmware was up to date at the time of replacement shell.
when I turn it on it won’t connect to the tx and if I set the tx to bind mode with the flashing blue light and press the bind button on the P3 sonar nothing happens. I have a flashing red and green coming from the sonar and a flashing red from the gimbal.
It won’t allow an update as it has the current firmware already.
Also when I power it down it takes about 15seconds to shut down.
Where to go now?
Never been crashed or damaged in any way other than the hairline cracks from motor torque.
firmware was up to date at the time of replacement shell.
when I turn it on it won’t connect to the tx and if I set the tx to bind mode with the flashing blue light and press the bind button on the P3 sonar nothing happens. I have a flashing red and green coming from the sonar and a flashing red from the gimbal.
It won’t allow an update as it has the current firmware already.
Also when I power it down it takes about 15seconds to shut down.
Where to go now?