MKheng said:During flight my gimbal keeps dropping and then resetting especially at height.
Has anyone else experienced this or have a cure?
Thanks
Sent from my iPad using Tapatalk HD
MKheng said:During flight my gimbal keeps dropping and then resetting especially at height.
Has anyone else experienced this or have a cure?
Thanks
Sent from my iPad using Tapatalk HD
edunwody said:MKheng said:During flight my gimbal keeps dropping and then resetting especially at height.
Has anyone else experienced this or have a cure?
Thanks
Sent from my iPad using Tapatalk HD
Return immediately.
Sent from my iPhone using Tapatalk
MKheng said:I think I may have found the problem. The cable from my GoPro to FPV TX I think is too heavy. I disconnected it and held the Phantom and situated some banked turns and high rises and turned the axis to look ahead and down and no problem. Connected the lead and problem. Just need to find a lightweight cable now!
Sent from my iPad using Tapatalk HD
MKheng said:I think I may have found the problem. The cable from my GoPro to FPV TX I think is too heavy. I disconnected it and held the Phantom and situated some banked turns and high rises and turned the axis to look ahead and down and no problem. Connected the lead and problem. Just need to find a lightweight cable now!
Sent from my iPad using Tapatalk HD
One must turn so I hope one fixes that.boat chaser said:I've found it enters hibernation mode very easily when turning. Forward/back or side/side seem to be fine.
If its a FW issue that will help everyone. If its a HW issue then there will need to be a huge recall.boat chaser said:I'm hoping they will release an update to make the gimbal a bit tougher. I have to use standard mount for fast fpv.
MKheng said:OK. Problem solved (almost). Lead made and works a treat, just needs 90 degree Mini USB plug and it'll be fine. The weight of a normal lead and the stiffness is simply just too much
Sent from my iPad using Tapatalk HD
MKheng said:OK. Problem solved (almost). Lead made and works a treat, just needs 90 degree Mini USB plug and it'll be fine. The weight of a normal lead and the stiffness is simply just too much
Sent from my iPad using Tapatalk HD
cvant said:The GCU is made so that you can plug into it instead of the GoPro camera for the video feed. You should not be plugging anything into your GoPro as you show in this photo. That is what the extra cable that came with the Zenmuse is for. It goes from the GCU to the transmitter to send the video signal. Plugging anything into the GoPro will throw it out of balance and will send it into hibernation.