Hello, I purchased a phantom this week from quadrocopter.com and got it today. I have watched all the preflight videos and have also installed the new firmware as recommended in the in the start up manual.
I turn on my remote, i then plug in the battery to the unit. It beeps and goes though the normal startup.
I'm then shown a yellow and red light to recalibrate the compass. I then switch the gps/atti switch 10 times quickly as shown in the video. Nothing happens.
When i try and fire up the motors nothing happens. Am I missing something?
Nothing seems to make the unit respond to the remote. Any suggestions? Am I missing something?
Thanks!
-luke
I turn on my remote, i then plug in the battery to the unit. It beeps and goes though the normal startup.
I'm then shown a yellow and red light to recalibrate the compass. I then switch the gps/atti switch 10 times quickly as shown in the video. Nothing happens.
When i try and fire up the motors nothing happens. Am I missing something?
Nothing seems to make the unit respond to the remote. Any suggestions? Am I missing something?
Thanks!
-luke