Phantom 4 Series - Propeller Mounting Plate | DJI Store
Be sure to buy 2 sets for 4 motors
Go from this
To this
Be sure to buy 2 sets for 4 motors
Go from this
To this
Last edited:
What exactly is the difference?
Just havin a read,,,they r bad design(originals)mine feel bit flopy but holdin on ,,they shoud have threds on for safetyThe spring that holds the prop in place, I guess they didn't like their original design either.
Sent from my iPad using PhantomPilots
They should not have "threds" on them, if they are taken off after every flight to pack the AC away that would be a major pain and it would be a certainty that they eventually would be cross threaded and/or over tightened by hamfisted operators.Just havin a read,,,they r bad design(originals)mine feel bit flopy but holdin on ,,they shoud have threds on for safety
Good idea,,yep i see ya point,,,,like your hamfisted expression,,my spring gona get light bend after readin that,,They should not have "threds" on them, if they are taken off after every flight to pack the AC away that would be a major pain and it would be a certainty that they eventually would be cross threaded and/or over tightened by hamfisted operators.
I assume there is a little compression spring on the shaft to replace the original part, I wonder if the original spring could be left in place when the new hub is fitted for extra safety.
What is needed to take the screws off then back on? An Allen wrench? Anything else? Is there a 'glue' needed too to keep the screws in tact when putting the new ones on? Loctite?
Sent from my iPad using PhantomPilots
Phantom 4 Series - Propeller Mounting Plate | DJI StoreI cannot find the upgraded P4 prop mount on the DJI Store. Help.
Sent from my iPad using PhantomPilots