- Joined
- Dec 25, 2013
- Messages
- 10
- Reaction score
- 0
Hello everyone,
Purchased the P2V at the end of November and have successfully run 4 full batteries with no issues. I decided to perform the latest firmware updates on both the P2V and the transmitter.
Since I've run the updates, I'm showing flashing yellows on the P2V and have lost transmitter communication with the P2V. I've checked and reloaded both the P2V and the transmitter updates. I'm able to calibrate the transmitter through the RC Assistant, but when I try to use the transmitter through the P2V Assistant, nothing happens. I'm also receiving an error message when the P2V is plugged in through the USB.
The error is
CFG-ERR ,followed by this message---Configuration error, this may cause by firmware upgrade from old version, or abnormal Tx calibration. Re-calibrate your transmitter and power cycle your controller and check all of the parameters.
The transmitter has a solid green light and the P2V isn't showing a "link" light. Both the transmitter batteries and P2V battery are fresh. I've tried to relink the transmitter and receiver per the manual, but the receiver isn't flashing.
I've been all over the forums with no luck concerning this issue with the new P2V, only the Phantom.
Any suggestions?
Great site by the way!
Purchased the P2V at the end of November and have successfully run 4 full batteries with no issues. I decided to perform the latest firmware updates on both the P2V and the transmitter.
Since I've run the updates, I'm showing flashing yellows on the P2V and have lost transmitter communication with the P2V. I've checked and reloaded both the P2V and the transmitter updates. I'm able to calibrate the transmitter through the RC Assistant, but when I try to use the transmitter through the P2V Assistant, nothing happens. I'm also receiving an error message when the P2V is plugged in through the USB.
The error is
CFG-ERR ,followed by this message---Configuration error, this may cause by firmware upgrade from old version, or abnormal Tx calibration. Re-calibrate your transmitter and power cycle your controller and check all of the parameters.
The transmitter has a solid green light and the P2V isn't showing a "link" light. Both the transmitter batteries and P2V battery are fresh. I've tried to relink the transmitter and receiver per the manual, but the receiver isn't flashing.
I've been all over the forums with no luck concerning this issue with the new P2V, only the Phantom.
Any suggestions?
Great site by the way!