Well i have the ribbon seated properly i hope..its missing the lock down latch.i used kapton tape to keep it on the camera board..i. noticed that when installing the camera cover it gets hot after a few min? I need a pic very close up to see it mabe its installed right...this has been a pain in the ***.because i cant seem to find the issue..also im loosing my wifi after binding.....three beeps means something with the actual camera (where the lens) module is wrong or the cable is not seated properly.
Only problem is were to get a holddown latch? It top of the gimble were the main connection the long latch is missing also..how whould apply pressure enough to make contact?Without the plastics lockdown latch it won't work. That's your problem right there.