So my app says update required.. just fitted a used but good gimball main board.
I put the bin file on a freshly formatted SD card, insert and turn on...
I'm getting 36 red/green flashes like its updating, but then I get about 6 sec of fast green, a pause, then another 6 sec this goes on 5 times, then back to the red/green for another 36 times... this just continues.
I've had a cold fan blowing on it the whole time...
Tried re formatting, downloading file again... no change...
No txt file is being generated on the card to say what's happened either
and the app reports the sd card (tried 3) as having 0mb capacity. so i guess not even seeing it hence no update?
I then tried the old gimbal board just out of curiosity and it shows the same, sd card capacity 0MB
but latest firmware...
The gimbal is all working, does its dance and camera can be moved.
This may be important ….. All the camera options on the dji app are grayed out.. cannot change or adjust anything as if camera is not there? So cant format the sd card in the app.
Any ideas please... ?
The ac and remote were at latest firmware before I fitted new board, tried litchi, tried different cables.
Im nearly giving up on it to be honest, ive exhausted every avenue..
I put the bin file on a freshly formatted SD card, insert and turn on...
I'm getting 36 red/green flashes like its updating, but then I get about 6 sec of fast green, a pause, then another 6 sec this goes on 5 times, then back to the red/green for another 36 times... this just continues.
I've had a cold fan blowing on it the whole time...
Tried re formatting, downloading file again... no change...
No txt file is being generated on the card to say what's happened either
and the app reports the sd card (tried 3) as having 0mb capacity. so i guess not even seeing it hence no update?
I then tried the old gimbal board just out of curiosity and it shows the same, sd card capacity 0MB
but latest firmware...
The gimbal is all working, does its dance and camera can be moved.
This may be important ….. All the camera options on the dji app are grayed out.. cannot change or adjust anything as if camera is not there? So cant format the sd card in the app.
Any ideas please... ?
The ac and remote were at latest firmware before I fitted new board, tried litchi, tried different cables.
Im nearly giving up on it to be honest, ive exhausted every avenue..
Last edited: