Brand new Phantom. Took it outside to calibrate and when I started the process, the light just started blinking yellow steadily. The manual says its lost its connection to the transmitter but I know it sees it. I can see the led on the board where the pairing button is turn on and off when I turn on and off the transmitter. So I keep digging but I don't see any real solutions. One said they sent theres back like it was just a bad device. Some made reference to a bad compass. Ive seen a video of trying to use a magnet to get it back to calibration range but that light is a red/yellow light flash. This is strictly yellow.
My steps were to install the latest Assistant software
Then I ran the firmware upgrade of 4.02
Then I loaded the default parameters
Then that's when I took it outside for calibration.
Ive gone through every document I could find and every youtube video but only find the one that is the exact problem (hes the one who just sent it back)
Anybody else have any suggestions?
My steps were to install the latest Assistant software
Then I ran the firmware upgrade of 4.02
Then I loaded the default parameters
Then that's when I took it outside for calibration.
Ive gone through every document I could find and every youtube video but only find the one that is the exact problem (hes the one who just sent it back)
Anybody else have any suggestions?