Solding tinn for upgrading my Phantom

[baiaz]

I have NEVER don soldering in my entire life...

And it is not easy. Or I am doing it wrong.

Or maybe my tinn is tooo thin... so any tips?

How to soldering - without missing up my phantom. and - it is no turning back now. so... what do I do to make the DAMD tinn stick while soldering???

 

[jumanoc]

First, you have to use soldering paste in the 2 pieces to join. Then you melt some tin with hot iron in the 2 pieces, finally you join the 2 pieces and hot both with iron until tin melt and inmefiatly you leave then get cool and tight. Just practice with some wires and pieces before mess with phantom electronics To much hot in some circuit boards, can ruin them easily... So test before...

Here you have HOW TO. infrienly videos:

http://www.youtube.com/results?q=so...1ac.1.23.youtube-reduced..0.3.140.hRH-B1P4oYk

 

[baiaz]

Thank you!

 

[tanasit]

If you are just replacing the motor(s), cut the wires in stead of trying to remove the wire ends from the board.
Then soldering two wires is a lot easier. Many ruined the board just trying to remove the wires.