Solding tinn for upgrading my Phantom

Joined
May 9, 2013
Messages
79
Reaction score
0
I have NEVER don soldering in my entire life...

And it is not easy. Or I am doing it wrong.

Or maybe my tinn is tooo thin... so any tips?

How to soldering - without missing up my phantom. and - it is no turning back now. so... what do I do to make the DAMD tinn stick while soldering???
 
First, you have to use soldering paste in the 2 pieces to join. Then you melt some tin with hot iron in the 2 pieces, finally you join the 2 pieces and hot both with iron until tin melt and inmefiatly you leave then get cool and tight. Just practice with some wires and pieces before mess with phantom electronics ;) To much hot in some circuit boards, can ruin them easily... So test before...

Here you have HOW TO. infrienly videos:

http://www.youtube.com/results?q=so...1ac.1.23.youtube-reduced..0.3.140.hRH-B1P4oYk
 
If you are just replacing the motor(s), cut the wires in stead of trying to remove the wire ends from the board.
Then soldering two wires is a lot easier. Many ruined the board just trying to remove the wires.
 

Members online

No members online now.

Forum statistics

Threads
143,066
Messages
1,467,359
Members
104,936
Latest member
hirehackers