- Joined
- Jul 28, 2013
- Messages
- 29
- Reaction score
- 0
I'm hearing some not so good reports about the main circuit board in the Phantom having those extra high heat solder joints and in another forum someone has melted the circuit board trying to remove the solder from the ESC's.
So since I need to install a Zenmuse Gimbal. I was wondering that rather than soldering the PMU direct to the solder point that DJI recommend in their 'How to' Gimbal videos.
Is it wiser to cut the power cable and maybe make a manual Y connection so that I'm soldering the wires rather than the joints on the circuit board?
-Frank
So since I need to install a Zenmuse Gimbal. I was wondering that rather than soldering the PMU direct to the solder point that DJI recommend in their 'How to' Gimbal videos.
Is it wiser to cut the power cable and maybe make a manual Y connection so that I'm soldering the wires rather than the joints on the circuit board?
-Frank