I am flying out to a job site in the morning. So this morning I checked for updates before packing up my gear. RC firmware update required. I do the update, and now my iPad Air II (iOS version 11) will not connect to the RC or the Aircraft. I flew it about a month ago with zero issues. I have searched a hundred threads, and done everything I can think of, wiped iPAD in iTunes, formatted SD card, cleared DJI GO 4 caches and deleted reinstalled, swapped cables, turned everything on and off in multiple sequences, refreshed firmware install in DJI Assistant 2, reupgrading RC fails at 2%, rolling back fails at 2% etc etc etc.
The RC is connected to the aircraft, I can tilt the gimbal and fire the motors, but the DJI Go 4 app is not connected to the RC or the aircraft. I have a second P4 that i have not done the RC firmware upgrade to, and the app connects fine with that aircraft. It does state that an RC firmware upgrade is required, but I am not going to do that... I hope I can limp through the job with the aircraft that still connects. I am flying the mission on Thursday, so I have a little time to continue to troubleshoot, but I am running out of airspeed and ideas. Any help out there?
The RC is connected to the aircraft, I can tilt the gimbal and fire the motors, but the DJI Go 4 app is not connected to the RC or the aircraft. I have a second P4 that i have not done the RC firmware upgrade to, and the app connects fine with that aircraft. It does state that an RC firmware upgrade is required, but I am not going to do that... I hope I can limp through the job with the aircraft that still connects. I am flying the mission on Thursday, so I have a little time to continue to troubleshoot, but I am running out of airspeed and ideas. Any help out there?
Last edited: