Hi, i just installed the upgrade for the Phantom 1. The board upgrade. I installed the H3-2D afterwards.
When I start the Phantom without remote the H3-2D lines up and does it work.
When I start the remote the h3-2D pitches full down. I can't controle it with the mounted lever on the back of the remote.
When I put my Phantom on the computer with the Naza software it shows me that my remote works but only the pitchcontrole (x1) does nothing!
I updated al the software. This is the remote (it was already good), the Phantom(needed an update for the new motherboard) and the gimbal. Al good.
Can anyone help me? There weren't a lot of plugs in de NAZA controleunit so I cannot made a lot of mistakes. The only thing was different from the DJI instruction video is that I have 2 antennas on the motherboard(x2 en x3 in naza-unit)
When I start the Phantom without remote the H3-2D lines up and does it work.
When I start the remote the h3-2D pitches full down. I can't controle it with the mounted lever on the back of the remote.
When I put my Phantom on the computer with the Naza software it shows me that my remote works but only the pitchcontrole (x1) does nothing!
I updated al the software. This is the remote (it was already good), the Phantom(needed an update for the new motherboard) and the gimbal. Al good.
Can anyone help me? There weren't a lot of plugs in de NAZA controleunit so I cannot made a lot of mistakes. The only thing was different from the DJI instruction video is that I have 2 antennas on the motherboard(x2 en x3 in naza-unit)