So I watched the video. You have a wire cut (maybe two) to the battery and you expect the controller to report everything is OK? Sheesh. If you can't figure THAT out, don't go modding the pack.
no the reason i cut the wire is to discnnect the battery from the pcb , and also connect it direct to the led to show the battery is working fine.
the battery is not buldgy so the battery is healthy.
when trying to turn on battery by pressing button the led shows 1 light then turns off this shows their maybe 1 battery cell pack damaged or the pcb is damaged so right now am de soldering each 1 and diagnosing the problem , after all battery legs are disconnected from board i will connect it 1 by 1 and turn the board on to se if it works.
last thing i will do is change the pcb board.
if u look at vide the battery cell packs has no pcb to them so u can just solder it out of their and replace it with any brand of your choice the main thing that needs to be thier is the pcb board so dji thinks its original simple as that.
people that has less electronic knowledge will just send the battery to dji or bin it , in that case u should not i wanted to bin it but then i opened it and checked everything with battery was fine , just minor problem that can get this battery working and fixed again.
if i connect this battery direct onto my drop 100% it will work i know but first am working to se what is the cause of this auto shut down since nobdy on youtube has found a fix so i will look forward to find a fix or maybe others can do this is simple easy fix