I am trying to repair a friends P3A. The AC initialises OK and the gimbal functions OK. The Remote will fly the AC and tilt the gimbal. But that about all
The DJI go app will not connect. I have relinked the RC to AC but the DJI Go app remains "disconnected" Hence no video, status telemetry, and cant check firmware, or set basic settings. I discovered on the first test flight the remote was mode 1 which was a surprise for a mode 2 guy
I have tried to update the firmware via SD card but fails. Green -red flashes then 4 10 second groups of rapid green flashed then back to green-red flashes and the cycle repeats. No TXT file was written to the SD to advise success, failure or abort.
Pulled the gimbal down and no obvious problems(damage or burning) with ribbon cable, circuit board or connectors.
Would appreciate any suggestions or advise to get this phantom going properly. Which circuit controls the data link between the AC and the RC?
Thanks
The DJI go app will not connect. I have relinked the RC to AC but the DJI Go app remains "disconnected" Hence no video, status telemetry, and cant check firmware, or set basic settings. I discovered on the first test flight the remote was mode 1 which was a surprise for a mode 2 guy
I have tried to update the firmware via SD card but fails. Green -red flashes then 4 10 second groups of rapid green flashed then back to green-red flashes and the cycle repeats. No TXT file was written to the SD to advise success, failure or abort.
Pulled the gimbal down and no obvious problems(damage or burning) with ribbon cable, circuit board or connectors.
Would appreciate any suggestions or advise to get this phantom going properly. Which circuit controls the data link between the AC and the RC?
Thanks