Hi to everyone,
I have recently bought a used Phantom 1 (P330) with the SR6 transmitter. Although I haven't flown it outdoors yet, I have very briefly and carefully hovered it indoors to make sure it actually lifts-off and this is fine - pitch n yaw seem to work well so no major issues there.
However I have downloaded the firmware (Naza M V2) and connected the quad several times but the software simply isn't recognizing that the machine is connected. Now I have already read about the driver issues on Windows 10, so I have tried downloading it with driver signature disabled but the problem still persists.
I also know that sometimes the USB cable can be at fault, but with me the laptop 'beeps' as normal whenever any new device is connected so I can't imagine this is the issue either. Help!
As a slightly separate issue, I thought that there was a USB socket inside the SR6 transmitter but there isn't one in mine? As I hope to install a gimbal at some point is this going to be an issue? And because of the age of the P330 I have been told that the gimbal lever kit for the SR6 is no longer available here in the UK so any suggestions on this would be gratefully received.
P.S. Although I am a wrinkly 62 year old, I have been flying 250 sized FPV quads for a while, so while I'm new to DJI I like to think I'm not a complete noob..!
I have recently bought a used Phantom 1 (P330) with the SR6 transmitter. Although I haven't flown it outdoors yet, I have very briefly and carefully hovered it indoors to make sure it actually lifts-off and this is fine - pitch n yaw seem to work well so no major issues there.
However I have downloaded the firmware (Naza M V2) and connected the quad several times but the software simply isn't recognizing that the machine is connected. Now I have already read about the driver issues on Windows 10, so I have tried downloading it with driver signature disabled but the problem still persists.
I also know that sometimes the USB cable can be at fault, but with me the laptop 'beeps' as normal whenever any new device is connected so I can't imagine this is the issue either. Help!
As a slightly separate issue, I thought that there was a USB socket inside the SR6 transmitter but there isn't one in mine? As I hope to install a gimbal at some point is this going to be an issue? And because of the age of the P330 I have been told that the gimbal lever kit for the SR6 is no longer available here in the UK so any suggestions on this would be gratefully received.
P.S. Although I am a wrinkly 62 year old, I have been flying 250 sized FPV quads for a while, so while I'm new to DJI I like to think I'm not a complete noob..!