First off, I searched for other similar issues on here but couldn't find any that have never been flown before not working with firmware upgrade. Thanks for any and all help!
So I purchased the Phantom 3 Pro in December and due to terrible weather, yesterday was the first time I turned it on to initiate the set up. As I began going thru the set up of the DJI Go app It informed me I need to upgrade firmware on MY RC/Battery/Copter. I followed the instructions and began process to upgrade to V1.10. It started with the 4 Beeps for about 8-10 minutes then just started making a crackling sound void of distinct beeps. Not the long beep followed by two beeps indicating it was complete. I have formatted the SD card and retried downloading the software on my PC, (previously done on mac) and receive the same issue. DJI support offered no help. Any help would be truly appreciated.
So I purchased the Phantom 3 Pro in December and due to terrible weather, yesterday was the first time I turned it on to initiate the set up. As I began going thru the set up of the DJI Go app It informed me I need to upgrade firmware on MY RC/Battery/Copter. I followed the instructions and began process to upgrade to V1.10. It started with the 4 Beeps for about 8-10 minutes then just started making a crackling sound void of distinct beeps. Not the long beep followed by two beeps indicating it was complete. I have formatted the SD card and retried downloading the software on my PC, (previously done on mac) and receive the same issue. DJI support offered no help. Any help would be truly appreciated.