P3 PARTS

[Cutter52]

I have a P3 4K drone and the module behind the camera lens has a bad connector where the ribbon cable goes. Some very small contacts came out while changing the ribbon cable. I know the Pro/Adv 4k camera entire units won't fit the P3 4k but I think the board behind the lens should be the same board. I will take one if you have it. I need this drone operating again. How do we get in contact?

 

[Billy Banana]

i need a roll motor P3S
could use a few other parts too. please respond
see parts circled in photos below

 

[armando208]

Hi,
I'm looking for p3s gimbal do you have any that are in good condition?

 

[Grandpa Don]

Do you by chance have good P3 standard controller (RC unit)?

 

[Dark flyer]

I need the whole camera *** for my p3s from the bottem of the drone down it had a meeting with a tree i guess it's called the gimble, can you help and how much

 

[Jthomp]

I'm looking for a P3S circuit board - the one just above the yaw control motor. Mine is missing the 2nd set of contact pins from the right. I still have the pin - I just don't have the skill or the equipment to solder it back onto the board.

 

[vatechnuke]

I am looking for a P3S gimbal pivot (roll) arm with motor attached. Do you by chance have one of those?

 

[captainmilehigh]

I am looking for a P3S gimbal pivot (roll) arm with motor attached. Do you by chance have one of those?

The guy to ask is Hani Lanzi of uavrepairshop.com.

@hunch,....can you help out here?

 

[Epro]

Need a P3S camera. Will buy or trade you a P3A camera for it. Thanks