I downloaded the file, extracted/unzipped the bin file, and pasted it onto the memory card using the micro USB cable. I unplugged the USB cable from the drone, and nothing. The gimble light just stays green. It doesn't flash between red and green, and it doesn't turn red, it just stays green.
After many attempts, I decided to try v1.8.80 instead, and it updated sucessfully. However, the drone's propellers would not power on even though the app said that drone was flying. I deleted v1.8.80 and tried v1.9.60, and got the same result. The drone would sucessfully update, but the propellers wouldn't power on even though the app said that it was flying.
Notes:
*I kept the controller off while trying to update.
*The battery is fully charged.
*The controller's firmware has been successfully updated.
*I did unzip/extract the bin file before putting it on the memory card.
*In the app, I get a Firmware Upgrade Required message, that says the aircraft and the camera need to be updated.
I can provide more details if necessary.
After many attempts, I decided to try v1.8.80 instead, and it updated sucessfully. However, the drone's propellers would not power on even though the app said that drone was flying. I deleted v1.8.80 and tried v1.9.60, and got the same result. The drone would sucessfully update, but the propellers wouldn't power on even though the app said that it was flying.
Notes:
*I kept the controller off while trying to update.
*The battery is fully charged.
*The controller's firmware has been successfully updated.
*I did unzip/extract the bin file before putting it on the memory card.
*In the app, I get a Firmware Upgrade Required message, that says the aircraft and the camera need to be updated.
I can provide more details if necessary.