I damaged the antenna leads on my P2 while replacing the shell after a bad crash. Besides metal fastener inserts that came from "attached", nothing else appeared to be damaged until I broke the antenna wire in disassembly. Since the antenna wires were permanently attached to the receiver board, I had to buy a new replacement. And yes, it is the correct 2.4 Ghz board. I'm not able to link to the receiver, have verified that the receiver is operational and calibrated using the RC Assistant software. I pressed the button on the bottom of the new receiver board in trying to establish a link, but still no go. Question is, the two connectors that come from the NAZA X1 and X2 to the receiver board appear to be identical. X1 is going to the right side connector on the receiver, and X2 is on the left. Could they be swapped, thus causing my problem? I haven't been able to find a diagram that covers the DJI 2.4 receiver, and I don't have the insight to figure this out on my own. Anyone out there have a reasonable answer? Many thanks
Last edited: