hobsonmedia said:
I updated to the latest edition, which I believe is 1.1. Are you aware of a newer version I should be using be used 1.1 isn't doing the trick.
There a couple things you need to do.
#1 uninstall your RC Assistant and download RC Assistant 1.1. It is named the same but apparently there are changes.
#2 hook new RC to RC Assistant and calibrate it. This means ALL controls (sticks, S1,S2, and X1) make sure to move through full ranges.
#3 shut down RC Assistant and hook up Phantom. Go to update page and make sure Gimbal firmware is at latest version.
Then click on basic button and select RC tab.
Select the radio button for "upgrade model" remotes.
Click on calibrate (below controls) and go through full ranges. Then click on calibrate to the right of X1 and again scroll the wheel all the way to top and all the way to bottom.
Then power off Phantom and let it cool down. After about 1/2 hour start Phantom Assistant with Phantom plugged in. Once you power Phantom up go quickly to the tools and perform an advanced "full IMU calibration" This needs to be done on level surface while IMU is not too hot.
Once done power Phantom down. Unplug it from computer. Power it back up and the tilt should stop wherever you let off the X1 tilt wheel.
Hope this helps.